Graphical representation of sensor data with Blender

An open space where people who use Blender in an academic environment can share progress and the typical problems and needs of academic environments.

Moderators: jesterKing, stiv

armen
Posts: 1
Joined: Sat Jul 24, 2010 7:34 am

Graphical representation of sensor data with Blender

Postby armen » Sat Jul 24, 2010 7:36 am

Does anyone know if it possible to do some-what physical simulation with blender (probably better call it graphical representation)?

So .... During functional test of electrical board, one set of pins push from bottom, another set of pins push from top. And ideally, the force from top and bottom should be the same, so that board would not bend or break.

If all the data is available, can this be represented graphically?
(there are already different sensors on the board to measure the pressure from those pins. The problem is that the data which comes from all those different sensors are all independent, it doesn't give a "big picture").

MonZop
Posts: 25
Joined: Wed Dec 16, 2009 9:51 am
Location: Pisa

Postby MonZop » Wed Jul 28, 2010 6:20 pm

It should not be too difficult.
What's the format of your data?


Return to “Academic & Research”

Who is online

Users browsing this forum: No registered users and 0 guests