Search found 6 matches

by rgutierrez
Sat Dec 15, 2012 8:06 pm
Forum: Interface & Tools
Topic: Cylinder with Holes in Top Face
Replies: 11
Views: 5703

OK. I just thought it might be an easier way to do it. Have you actually tried it? It might be fine for your project. Anyway, always good to have options. Good luck with your creation! I agree. I'm actually trying to use boolean modifiers to make different holes in my design, to try it out. Thanks ...
by rgutierrez
Sat Dec 15, 2012 7:22 pm
Forum: Interface & Tools
Topic: Cylinder with Holes in Top Face
Replies: 11
Views: 5703

Couldn't you just place smaller cylinders in the face where you want holes, and then just use the boolean modifier with 'difference"? After you apply it, you can delete the cylinders. If you want several holes, join all the smaller cylinders into one object to use as the boolean object, so you can ...
by rgutierrez
Sat Dec 15, 2012 7:21 pm
Forum: Interface & Tools
Topic: Cylinder with Holes in Top Face
Replies: 11
Views: 5703

joaclint wrote:I recorded this video for you while you got it. Anyway here it is :)
http://youtu.be/wt0HKf6oD50
Sweet! Thanks. What did you use to record that?
by rgutierrez
Sat Dec 15, 2012 6:13 pm
Forum: Interface & Tools
Topic: Cylinder with Holes in Top Face
Replies: 11
Views: 5703

Thanks. Not sure what I'm missing. I tried the instructions above, as well as the instructions in this post: http://blenderartists.org/forum/showthread.php?139417-Brake-discs-using-curves For some reason, when I create concentric circles using bezier circles, I can't convert the circles to a single...
by rgutierrez
Sat Dec 15, 2012 5:29 pm
Forum: Interface & Tools
Topic: Cylinder with Holes in Top Face
Replies: 11
Views: 5703

Thanks. Not sure what I'm missing. I tried the instructions above, as well as the instructions in this post: http://blenderartists.org/forum/showthread.php?139417-Brake-discs-using-curves For some reason, when I create concentric circles using bezier circles, I can't convert the circles to a single ...
by rgutierrez
Fri Dec 14, 2012 5:22 pm
Forum: Interface & Tools
Topic: Cylinder with Holes in Top Face
Replies: 11
Views: 5703

Cylinder with Holes in Top Face

Hello - I'm looking to create a cylinder with several holes in the top face. I tried subdividing the top face to be able to remove holes to convert to round holes. However, only the edges around the top face are subdivided. The face itself is not. I also tried using bezier circles to create a round ...