Alt-M, minor bug

Devas73 · Post by **Devas73** » Mon May 19, 2003 2:40 pm

Hello,
using alt-M on a mesh and then pressing u to undo the operation will make the mesh disappear into void.

iluvblender · Post by **iluvblender** » Mon May 19, 2003 5:19 pm

Hello,

are you sure?

i checked it. it works fine for me!!!

- Satish.

Devas73 · Post by **Devas73** » Tue May 20, 2003 12:38 pm

Strange: doing it with a cube (selecting two near vertex) and alt-M, then U the mesh disappear - doing it with a plane works...

NateTG · Post by **NateTG** » Tue May 20, 2003 10:01 pm

make sure you have exited, and then entered editmode after you create it. If you create an object, and hit U without exiting and then entering editmode at least once, the object will dissappear no matter what you did while in edit mode.

I think the object state is "saved" only when you enter editmode, and loaded when you hit U. unfortunately, if you have not entered editmode, there is no saved state, and thus, nothing to load.

Devas73 · Post by **Devas73** » Wed May 21, 2003 3:54 pm

It works! If I create a cube, exit edit mode, reenter edit mode and do alt-M and u, the problem no more arises.