Page 1 of 1
Going over 100% (feature request)
Posted: Sun Mar 20, 2005 5:33 pm
After a chat in #blenderchat a feature request was suggested. I know that in tuhopuu 3 it's possible to input a costum value in to the render % bar, but it's impossible to exceed the 100%. Our feture request if you didn't understood it already is to enable a 100%+ value in the %size bar, instead of getting a calculator out and doing it manually.
Posted: Thu Mar 24, 2005 5:16 am
Hear, hear! Goes smaller, why not larger? Why not a slider, or valuebox rather than fixed increments? Second this motion!
Posted: Thu Mar 24, 2005 5:30 am
Done. You can give it a test in tuhopuu3.
Posted: Thu Mar 24, 2005 9:50 am
Maybe a "force aspect" toggle button is handy as well.
Then if I alter the SizeX then the SizeY is filled in for me.
Posted: Thu Mar 24, 2005 11:48 am
Good thinking, shouldn't be too difficult either. I'll put it on the todo list.
Posted: Fri Mar 25, 2005 6:37 pm
I thank you blender coders
Posted: Mon Mar 28, 2005 4:16 am
thanks everyone, and Aner for persuing it
this makes me happy.