Page 1 of 1

When I insert a mesh cylinder there isnt top or bottom

Posted: Thu Jul 18, 2013 1:51 pm
by evantheis
When I insert a mesh cylinder there isnt top or bottom vertices at all, I have reinstalled and updated to the latest program about 4 times now? What's going on?

Posted: Thu Jul 18, 2013 5:30 pm
by brasshat
Immediately after adding your cylinder, observe the tweak panel, either at the bottom of the tool shelf, or by pressing F6 key, and make certain that the option in the "cap fill type" selection box is something other than "nothing". This will cap your mesh cylinder.

ns