Page 1 of 1

too questions of newbie

Posted: Wed Aug 02, 2006 7:40 pm
by dagobert
is it possible when you create an object to always get it at 0 0 0 and not depending of the camera, may be in pref.
and is that possible to use the perspective view as camera so as to render picture( ifound the way to move the camera uneasy compared to the perp view)
thanks

Re: too questions of newbie

Posted: Wed Aug 02, 2006 9:07 pm
by kAinStein
dagobert wrote:is it possible when you create an object to always get it at 0 0 0 and not depending of the camera, may be in pref.
Put the cursor where you want to have a new object. It does not depend on the camera.
and is that possible to use the perspective view as camera so as to render picture( ifound the way to move the camera uneasy compared to the perp view)
thanks
Not sure what you want...

Posted: Thu Aug 03, 2006 12:26 am
by paulo_gomes
tou can align the active camera to the active view, goto view>align view>align active camera to view, or (crtl+alt+numpad 0). I hope this helps you.

Posted: Thu Aug 03, 2006 12:27 pm
by solmax
or you can open up the render preview panel in any 3D view by pressing "shift+P".