Blender's renderer and external renderer export
Moderators: jesterKing, stiv
- Posts: 3
- Joined: Wed Oct 23, 2002 4:56 am
I have a 1.8gHz machine I in the next room I would like to use for rendering. Blender causes an infinite loop in the graphics driver so I can't use it (but thats a story for another thread).
I've decided to use it for network rendering (hoping it won't crash), but when I start renderd.exe I get the following:
Code: Select all
Using BLENDER = blender.exe
Could not create socket. Error PR_ADDRESS_IN_USE_ERROR (just wait TIME_WAIT)
This is on both the 1.8 XP machine, and the 450mHz machine thats running broker.exe
Anyone ever run across this problem?
- Posts: 3
- Joined: Tue Oct 15, 2002 11:52 pm
Yes, I have. I think it was caused bu the borke and/or daemon not releasing the port correctly. At the moment I can't quite remember how I produced the error, but as far as i can remember it happened when i had stopped the daemon and the restarted it immediately or something like that. Sitting tight for a minute or so until the port was reclaimed by the OS and then trying again worked for me.
Hopes this helps.
- Posts: 521
- Joined: Wed Oct 16, 2002 12:53 am
- Location: Valencia-Spain-Europe
BrianNickel wrote:I have a 1.8gHz machine I in the next room I would like to use for rendering.
If do you use windows, you can try BlenderTools
in Spanish Blender website www.NicoDigital.com
Who is online
Users browsing this forum: No registered users and 2 guests