Fluid system vs Particle fluids?

General discussion about the development of the open source Blender

Moderators: jesterKing, stiv

Post Reply
Posts: 2
Joined: Fri Aug 24, 2012 9:44 am

Fluid system vs Particle fluids?

Post by jtelf2 » Thu Aug 30, 2012 9:38 pm

Hi all, I'm just getting back into Blender after some time away. It looks like there are now two ways of doing fluids, the fluid system (the one with the domain that you bake) and particle emitters set to "fluid" type.

I haven't been able to find any information about which system is best for what kind of simulation, or if one is replacing the other. Does anyone have a link to a good overview of the different uses of these two systems at all?

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest