Quick NURBS question

Blender documentation projects, tutorials, translation, learning & teaching Blender

Moderators: jesterKing, stiv

Post Reply
Posts: 1
Joined: Thu Nov 08, 2012 7:46 pm

Quick NURBS question

Post by tgmccallum » Thu Nov 08, 2012 7:52 pm

Complete blender nub here, just started using it. I was playing around with a NURBS circle, trying to make a simple plate. All I did was duplicate the circle a few times with shift + d and scaled it each time, then joined the faces with F, and got this:


How can I close up that empty spot in the center where the I originally put the NURBS circle? I figure it should be pretty simple, but I couldn't figure it out myself.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest